I am having problems with 36" soft seated butterfly valves. When the valves were disigned for vent gas compressor suction valves the styrene content was not taken into consideration so the TFE seat ri

I am trying to understand what the limits are of pre-compressor methanol injection on turbocharged cars. From my understanding, erosion occurs when you have the wrong combination of compressor speed a

Needle valves are recommended in the abundance of altered material. The valve is on the metal

The most important next-generation common rail system fuel injection system, the transformation is shown in Figure 15 using a piezoelectric fuel injection valve (Piezo-injector valve).

Many industrial machines using compressed air as an energy source, use air cylinders or other pneumatic actuators to do the actual work.

It would always stall and would take forever to get started. it would not even move me when I sat on it and my son had to use his legs to get it started.

I have a small Hardinge gang tool lathe with 5C and use homemade nylon pullers with no problem. Get yourself a 3' length of 1-1/4 and bore the hole ~.025" under size then use a hack saw and cut a cros

Hose barbs with 10-32 threads. It isn't attached directly to the regulator or solenoid. The NV55 is attached to the side of the stand and hose is run to the solenoid on one side and hose attaches it t