I have a 500 cc motorcycle engine that runs on methanol. I only want to run the machine a shows so is it possible to convert it to run on petrol,as it will never be racing.The compression is 15:1 igni

The facility that I work at requires valve guide wear to be measured before and after engine testing is performed. One of my co-workers does this procedure and using a digital dial bore gauge with a s

I'm about to design piping system inside oil production wellhead. Around 5 meters from Xmass tree I'll arrange a choke valve. My concerns is dealing with supporting this choke valve. I'd like to know

I am considering making my own distilled water misting system ahead of my condenser/compress unit to get more cooling power out of it.

I have heard of three alternate methods (vs the traditional one consisting of allowing 50 to 25% of the system frictional pressure drop excluding itself to the control valve) to determine the allowabl

I note that on globe and check valve the use of stellite as hard facing and corrosion resistant layer on trim parts is the best solution for many vendors.

Where can I find technical reference material for an Automax model R312PSR80 actuator? It is being used here with a butterfly valve on a 24" line. The positioner is an Automax H-4000 with 4-20 I/P

Do they make an intelligent air piston that cuts down air pressure near the end? Or can I fabricate one with electronic control? Difficult to implement?