We have been asked by a client to suggest changes to the existing pressure sensing line configuration to reduce the pressure oscillations seen in the transmitter output.

Application:Offshore race/pleasure boat,BBC,800-1300HP @6-7000 RPM,engines are well built w/details available. Problem:As these engines are used for pleasure, 92-93 octane is used.

I wonder whether there is a good equation to estimate gas (say, air) flow rate through a needle valve? Right now I know the pipe diameter (1/4") and the outflow pressure (20 psi).

I need some clarification regarding requirements on level bridle isolation valves. ASME Section 1 Steam Drum.

hi i am fairly new to the hydraulic business and need to create a hydraulic lift that has warm up loop that also raises the lift at the speed i choose based on the power given to the pump. and lowers

How many type of needle (pin) designs to control the pressure with a timer cap? (As much I know, there would be "slope" needle (no seals o-ring required, but you have to tight very hard to seal), and

Has anyone seen a water-powered control valve that might be used to regulate water supplied to a kids wading pool or splash pad - type recreational facility?

I